Condor

Tip

These steps are automatically verified and performed by SIMRIG Control Center. Start the game and follow the prompts issued by SIMRIG Control Center. Or use the auto-configure tool on the Settings Page.

Note

All aircraft share a single profile due to limitations in Condor

Edit a configuration file to enable telemetry:

  1. Close Condor

  2. Open the game’s installation folder and navigate to Settings

  3. Open UDP.ini with Notepad

  4. Set Enabled to 1 in the [General] section

  5. Set Host to 127.0.0.1 and Port to 55279 in the [Connection] section

  6. Save the file

  7. Done

The result should be similar to this:

[General]
Enabled=1

[Connection]
Host=127.0.0.1
Port=55279

Note

The default port in Condor is 55278. SIMRIG Control Center listens on 55279 unless otherwise configured under UDP settings.

If the game is not detected automatically, manually choose Condor 2 or Condor 3 as the telemetry source in SIMRIG Control Center (see Telemetry source selection). Press Show all to find it in the list.